I would think you need to keep the pump bodies exposed, or
at least the motor part of it.

|-> -----Original Message-----
|-> On Behalf Of Lee
|-> Sent: Tuesday, July 07, 2009 12:39 PM
|-> Subject: Re: UK_Selfbuild Insulating "awkward" bits of pipework
|->
|-> Thanks for all the replies.
|->
|-> I've ordered a couple of rolls of foam tape that looks like
|-> the Armaflex lagging tape but is cheaper (and will no doubt
|-> be crap!).
|->
|-> The boiler room (where the store is) gets very hot inside;
|-> the surface of the store itself is nice and cool so nothing
|-> much being lost there, so the room must be being heated by
|-> the various "awkward" bits of hot pipework, and therefore
|-> must be wasting quite a bit of energy.
|->
|-> The foam tape is only 3mm thick (as is the Armaflex stuff I
|-> believe) so I suspect I'll want a few layers to keep the
|-> heat in properly.
|->
|-> Anyone know if CH pump bodies should be left exposed, or
|-> whether they can be lagged too ?
|->
|-> Cheers
|-> Lee

This email (including any attachments) may contain confidential
and/or privileged information or information otherwise protected
from disclosure. If you are not the intended recipient, please
notify the sender immediately, do not copy this message or any
attachments and do not use it for any purpose or disclose its
content to any person, but delete this message and any attachments
from your system. Astrium disclaims any and all liability if this
email transmission was virus corrupted, altered or falsified.
-o-
Astrium Limited, Registered in England and Wales No. 2449259
Registered Office:
Gunnels Wood Road, Stevenage, Hertfordshire, SG1 2AS, England