firstly all was good with the car I brought from new, then it started problems, could not change gear unless I turned car off then restart to clear computer,...
On the rear of the Lombardini engine in the engine harness is a small BROWN wire that is terminated with an 8.5 mm crimped ring terminal and is attached to the...
Hi Paul, I had this problem last year and traced the problem to bad contacts on the auto choke sensor cables at the front left of the engine. I never removed...
Probably the same fault as the earlier Microcraps... ECU fault... Get a new one fitted before the warranty expires. Dont bother calling , go staright for a...
Hi, I need the dimensions for the Aixam 500 front bearing.Year 2001,engine Kubota Z482. I have a 2 mm clearance when I move the wheel. The balljoint and...
Hi Alex, it should be the same as in my 2002. I can not be absolutely sure, if your model is for the 45kmh market it may be different, for example brake disc...
... if you go for the deisel fuel roughly 83 miles per gallon down side on flat get around 50 to 55 miles per hour but any kind of incline speed drops off...
How can i get down driven pulley, marked on picture: Picture <http://www.shrani.si/f/D/Id/157VmpUs/slika2.jpg> I unscrewed female screw, but the pulley doesn't...
Hi Alex. The bar under the belt on my 500 is not straight. It is only there to keep the belt off the drive shaft joint, and touches the belt when the belt is...
I am looking for a transmission variable belt drive forward reverse and neutral for a Aixam 500/4 i have been trying to fin d this part for 2years i would...
Locate small Allen key grub-screw near the centre rim of driven pulley, unscrew a little and the pulley will close. I dont know what 'female bolt' you have...
Are you sure for this special tool? Have you picture of that? Now i have remove gearbox with pulley from car. http://shrani.si/f/i/YV/1bfdIQOx/slika1.jpg There...
Sorry, i didn't understand you at all. I am from Slovenia. I removed gearbox with pulley from car. So i can easy access. Here is another picture and you can...
What are you wanting to do? Remove pulley from gearbox shaft? Or adjust belt tension? ________________________________ From: mojsterb <mojsterb@...> To:...
Hi When I did this job I cut a length of wood 50mmx50mmx500mm. I cut this to taper to a sharp point at one end. Then with a hammer I forced it between the...
Hi , I have an Aixam city electric, it has only done 3200 miles, it's first MOT has just taken place. An advisory has been issued that the ball joints require...
Are you sure, that without this tool i can't get down the pulley from gearbox shaft? Aixam have different execution of pulley. "Garage" what did you mean with...
Hi BB. Do the plastic pieces "skids" look like these? http://homepages.enterprise.net/jayjay/images/aixam/newbelt17.jpg If they do then you do NOT have to...
Yes they looks like these. I still have pulley on gearbox shaft. And gearbox out of the car. I think there is something wrong with it because the pulley...
When I first changed the "skids" I did it in the car. No vice. The spring is strong and must be turned hard. It would be easier with 2 people but I can turn it...
on way home from work car fine, reach home hit window button to close and wiper and screen wash start without touching lever and window wont close and dash...
sounds like a earth problem not easy to track problem down just a case of checking all the connections are clean and tight, best of luck Paul ... From:...
