You can set the sort order of messages? Just click on the link in the date column. Your preferences will be remembered, so you don't have to do it again when you return.
Is there anywhere to get parts easily. I am in Devon. Scrappers are useless and I really love my Mazda and want to keep it for as long as possible(M reg) Jean...
Hi Jean, and welcome to the club... I would say the breakers are going to be the cheapest, and the best way to find something, is to use the find a part type...
Dear John, Arf Arf arf!!!BIG engine, very tempting. I tried 247 and suddenly saw after I had signed up that there was a £1.50 charge. That's OK if it is a 1...
Hi Jean, Sorry, I didn't know about the £1.50 charge on 247... they all used to be free.. Personally, I would try another one. As I said, the scrappers...
Thanks for all your help John. I have paid £40 for one from ebay scrapper but no guarantees it will not break in the post. We'll see.....Best wishes Jean ... ...
We have a Mazda 626 2002 reg, Estate, GXi SE, unfortunately my wife connected it (very gently) (hardly felt anything) to a wall and broke the near side...
Hi Mike, and welcome to the club.. Your part number is GG3E-51-070C The earlier (pre99) model is GE4T-51-070 My guess is that there is a slight difference.. ...
Hi John Many thanks - I've also had a reply from 1st choice spares - they are quoting me £46 including VAT and delivery, but I'll get them to check the...
To be honest Mike.. at that price, I'd enquire at the dealers first.. it seems very expensive for a pattern part.. they are normally around half that. John...
Ok thanks, will do these. Thought I'd do the fuel filter first, as it has never been changed, and I alredy have it. In one of your previous posts you said " it...
It is slightly different with your model, but the result is the same.. Lift the rear seat cushion, and remove the service hole cover. Disconnect the fuel pump...
ok thanks (you make this a great forum) - easy when you know how :) Have removed the fuel pipe at the top of the fuel filter. Can't seem to figure out how to...
The service manual only states the following:- release the fuel pressure disconnect the battery Remove the air cleaner disconnect the fuel hoses remove the nut...
hello all i have got mazda 626 year 2000 the passanger window dont go up or down where is the best place to try and look at where the fault is switches ect...
Hi Terry.. If any of the other windows work, then it is most likely to be a switch, or the motor itself.. If only the drivers works, check the on/off switch in...
The switch in the passenger door may pull out, although as with the drivers, may be screwed from the inside.. removing the panel is better any, as you will...
Hello all has any body got a drivers door window switch unit as this is what I need for mazda 626 on x reg year 2000 what have you got and how much thanks all ...
Hello to the group. My name is John, I live in Wareham. Dorset and I have just got myself a 1983 Mazda 626 LX. Is there anyone else got one out there, can...
Hi John, and welcome to the club.. You have the GC model, and as you have an LX, it will be a 1.6L with possibly manual windows, and no sunroof ? My Dad used...
Ok. Engine runs fine but temp gauge needle gets to the middle of the gauge quite quickly. It doen't go any higher than middle though BUT, I have not had the...
The definitive answer.. My 626 would start to get warm in about 2 minutes, and fully warm in about 10 minutes.. probably no more than a mile. The thermostat is...
I have an intermittent problem with starting the car. The problem, I think lies around the ignition switch, it is not the starter motor. I am told to check the...
Hi Habib.. There is no relay, other than the solenoid on the starter... If you are 100% sure that is fine, then the only other problem is the starter switch or...
Thank you John. As you say, I think it is the wiring. If I fiddle around with the wiring under the dash board the ignition work. I don't know which wire...
