Hello all has any body got a drivers door window switch unit as this is what I need for mazda 626 on x reg year 2000 what have you got and how much thanks all ...
Hello to the group. My name is John, I live in Wareham. Dorset and I have just got myself a 1983 Mazda 626 LX. Is there anyone else got one out there, can...
Hi John, and welcome to the club.. You have the GC model, and as you have an LX, it will be a 1.6L with possibly manual windows, and no sunroof ? My Dad used...
Ok. Engine runs fine but temp gauge needle gets to the middle of the gauge quite quickly. It doen't go any higher than middle though BUT, I have not had the...
The definitive answer.. My 626 would start to get warm in about 2 minutes, and fully warm in about 10 minutes.. probably no more than a mile. The thermostat is...
I have an intermittent problem with starting the car. The problem, I think lies around the ignition switch, it is not the starter motor. I am told to check the...
Hi Habib.. There is no relay, other than the solenoid on the starter... If you are 100% sure that is fine, then the only other problem is the starter switch or...
Thank you John. As you say, I think it is the wiring. If I fiddle around with the wiring under the dash board the ignition work. I don't know which wire...
It may just be a poor connection under the dash.. Open up the steering console housing, and you should get better access, also you will see the soldered...
Does anyone know if ford and mazda share the same parts? i am looking to replace timing belt and bits and was wondering if i could it cheaper as ford parts are...
In a similar mould, is the sump on the 2 litre 134 hp model the same as a ford one, as I need to replace mine as its rusting away!! I reckon a decent motor...
The 92-97 models did share a fair amount with the Ford Probe, but later models are different.. Ford/Mazda similarities depends on the car.. ie Mazda 121 and...
Hi My mazda 626, 1998 (newer shape), 2.0 litre. I need to take the rear wheel off to do some work on the car. I can jack the car up but I'm not sure where to...
Usually, there is 2 beams running down the car, one on each side.. they are clearly visible underneath and this is where you can place axle stands.. either at...
Greetings from the States! I joined the group a couple of years ago and have found the information interesting. Now, I need help. I have a 1991 626 that my...
Hi David, From what you say, it could be the fuel pump, or fuel pressure regulator... and I would lean towards the regulator.. This may be what you are calling...
Hi John, Sorry about forgetting to say which engine I had. It's the 4-cylinder. Don't remember whether it's 2.2 or 2.4L. The service manual refers to the ...
Hi David. Firstly, yes the ISC can be cleaned, but it is a little tricky due to it's position, and the likelyhood of springs and bits flying out.. The item on...
Hi John, Thank-you for the suggestions and will try to check it out this weekend. I just hope whatever it is doesn't start working again so I can find the ...
i'm trying to find the 16 pin obd connector that should be inside the cabin of my 2000 mazda 626 and cannot for the life of me find it! i've looked under and...
OBDII wasn't made law in the UK until 2003.. however, there are quite a few cars that had it well before that date, as it became law in the US many years...
