You can set the sort order of messages? Just click on the link in the date column. Your preferences will be remembered, so you don't have to do it again when you return.
you are right, i have sent in to mazda workshop for checkup, what there did are check the wiring from the a/t controller (behind ecu) to ecu & also to gear...
help! there's a leak in my (front) window washer tank. the haynes manual has no information on how to get the tank out of the car, and how to fix the leak. ...
as far as I know, the tank will come out from underneath the car.. Start with removing the plastic wheel arch covers, you should get a better view of things.. ...
i have excessive play in the clutch pedal. i took a look at it for adjustment purposes and it seems there is very little resistance from the pushrod until the...
It is most likely The pedal needs adjusting, or there is air in the system, or a fluid leak.... I have posted a page on pedal adjustment in the tech section......
... I checked the pedal adjustment (since the procedure is documented in Haynes) but the adjustment screws are at maximum already. Regarding leaks, if there is...
the engine will die-off after a few hours driving (2 hours or more). no codes has stored. when it start die-off, it will die-off again every 5 - 10 minutes...
It does sound like the ignitor module in the distributor... best advice is to buy the ignitor module from a Ford dealer, as Mazda will only sell a complete...
Very much a DIY project.. Basically, remove the distributor cap, a few more screws inside and the module and coil will come out.. just as easy to replace. for...
Hi, and welcome to the club. I would say anything is possible, if you have enough money.. although in this case, it may be cheaper than you think. The Protege...
626 executive 1989 (F) Drivers stored is stuck shut. Everything works OK, other doors, central locking etc, the knob goes up and down - the door just will not...
I have 92 mazda 626 GE and I noticed some coolant leak. After that I saw that coolant (some green liquid) is dripping from a hole under the car located near...
To remove the door card, you need the door open, as one of the screws is on the side.. it looks like a faulty lock, or the rods have come off.. You may have to...
Strange is the correct word... there are no coolant pipes inside the car, other than the ones that go to the heater matrix under the dash.. If there was any...
I have a 1988 626 coupe 2.0l 16v that has recently started to smoke quite heavily at start up. Its also using water at the moment but with no apparent leaks....
Hi Zack, and welcome to the club.. This depends on the colour of the smoke on startup.. Blue, and it's oil related, probably the valve stem seals as you say. ...
hello! Einstein! I have a Mazda MX6 '93 LS/V6 stick/manual shift. and also think I have a lotsa problems. When in first gear, it won't move that much, its like...
Hi hkoratala, and welcome to the club.. there should be no hesitation or "holding back" in first gear. It could be related to the codes you have pulled. ...
Hi nomiex.. Eibach make the best springs, and they are available for the 88 - 92 models.. part no 5511.140 they should fit the 4WS as well.. although the...
I don't know where to go online to get exploded views that are detailed and accurate here in the US for my 96' Ford Probe GT 24 valve 2.5 L (Mazda 626 engine...
Hi Sondi, and welcome to the club... Yes, I have everything you need.. (full genuine Mazda workshop manuals in fact) In the photo section there is a technical...
Oh my gosh, I am so greatful for your response and the help you are willingly offering. I really don't think you have any idea how huge of a help you have...
