Mazda mx3 V6 1.8i (one of the nice ones), red (coupe), average miles 1995 N-reg. EW, A/Wheels, E/S/R, ABS, E/M C/Locking. Good condition. Lots of service...
Hi all, Does anyone have a decent (cheap) recommendation for replacement springs. I have found a lowering kit of 4 for £125 but as it lowers by 40mm I think...
You sure you wanna lower it, try bigger wheels, I have 17 inch alloys with 225/45 tyres looks pretty good, hopefully the attached image gives you an idea, we...
You sure you wanna lower it, try bigger wheels, I have 17 inch alloys with 225/45 tyres looks pretty good, hopefully the attached image gives you an idea, we...
Thanks for that. The problem is that I appear to have cracked a spring and need to replace the front set as a result. I was looking into lowering kits as a...
I just paid $66 USD for this part from my local (michigan, USA) mazda dealer. It is part number k80113220d here in the states. ... leak ... and the ... ...
Tony I could use the black plastic box bit on the front bumper that holds the reg number plate on, I bumped into a car on Christmas eve, broke that bit and my...
I dunno about anyone else but I have never been able to access the Photos section, when I tried to add a picture a month or so back I had to put it in the...
We are few and far between, not a lot happens here. monsoonmarty <monsoonmarty@...> wrote: Hi to all you MX3v6 owners out there, just joined the group...
Hi Marty! monsoonmarty <monsoonmarty@...> wrote: Hi to all you MX3v6 owners out there, just joined the group and thought I would say hi. Look forward...
Hi folks, anyone out there know the reason and cure for said above noise. Its been doing it since I bought the car last year. Any suggestions/remedies would be...
There are two common causes of that noise on the K-series engines. One is a "collapsed" hydraulic tappet - it could be cleared by a good oil change, but if...
Hi All, just to let you know I joined your group today after buying an MX-3 a couple of weeks ago. I have a 93 L 1.8 V6. It is black with SE pack so its got...
of course. :-) has anyone fitted any of the gadgets on ebay that promise to boost power/ economy/ performance etc? do they compromise reliability or anything...
They are usually just a resistor in the line from the air temperature sensor. All they do is enrich the mixture, so you use more fuel than you need. They do...
thanks for that Ian. I suspected as much. what is recommended then if anyone knows? Also how often should we do cambelt changes? stuff I have says every 60k...
The most popular performance improvement is to fit a 2.5 litre KL engine, from a Xedos 9 or a 626 (not all had one!) You will encounter the KLZE engine,...
Hi folks, anyone any pointers as to what is causing this? A couple of days ago the idle speed started fluctuating between 750 and 400 rpm, now cutting out all...
... of ... One possibility is a vacuum leak, whereby unmetered air gets to the throttle body - the mixture is too weak and you know the rest. Look very...
looking for an alternator for K reg 1.6 auto import the part no ive got for a new one is DRA3176 any one got one going spare please loosing belts each week now...
Can anyone assist. Looking for the bottom section ( excuse the pun ) of the rear seat.It is vinyl/ cloth and blue / grey colour.Also what is the supposed top...
