Got y reg 1.9 jtd ,alot of time at low revs the car just stops for a while then just kicks in.Anyone had same problem,do they suffer from bad turbo lag.Peter...
My 2001 jtd aircon has stopped. Light comes on, but compressor clutch does not engage. Checked the fuses, all seem ok. Any hints?? C2 [Non-text portions of...
Hi mate, had this problem on the forum last year. I have just checked through my database of problems and found this posting. Hope it helps. Moriarty... ...
It's most likely run low on refrigerant - either through non-use or a leak. Get it regassed and tested at the same time, either via the dye/uv method or the...
... clutch does not engage. Checked the fuses, all seem ok. Any hints?? ... Sounds like your vehicle has lost its gas. Basically within the aircon system...
I'm looking to get the Cam belt on my petrol Multi changed, but my (very reliable) man-around-the-corner says you have to drop the front of the engine to get...
I can confirm that you do not have to drop the 1.6 engine. From memory, you have to take off the driver's side wheel & remove an access panel in the wheelarch,...
hi,could anyone please advise me on what size caravan is idealy suited for the multipla i,m looking at a 4/5 berth, without causing me problems i,ve towed a 2...
Hi everyone, i'm a new reader of this Y! Group from germany. This is one reason why my english isn't good. But i hope you could understand me :-) I'm looking...
Hi all, Mrs Moriarty and myself have decided its time to get rid of the old folding camper and have set our sites on a "Tin Tent". Now, I know that some of...
I did this job a little while ago. Took me around 4 hours, with no need to drop the engine. You can find my experience in the files section under 'JTD –...
... I'd be wary of anything much above 1000kg unladen, say 1200kg laden. My JTD pulled a 800kg van fine. You want to have a pleasurable driving experience,...
Hi Karsten i tried all the universal mirrors and none fitted all that well untill I tried a mirror made by Pyramid Products Limited called 'Suck-it-&-See ...
Cheers for that Stuart...I have seen a couple of these on sites in the past and they do look a bit of an oddity so perhaps they are well suited to the ...
... Go on - be a devil! I think that the philosophy behind them is quite different from the 'white boxes' which dominate the UK market. The latter seem to be ...
My JTD has had very clunky suspension for a while now. It was improved when the drop-links were done, but then got worse. It was probably the anti-roll bar,...
Is there some info on the owner's group about the 'nail trick', as i'm on second set of drop links and the knocking wasn't cured by the replacement. Toby. Jon...
It has been described a few times over the last few months (I can't take credit for it), but basically you push a 40mm nail between each of the bushes and the...
Ah I see, so all this does is compress the bush against the metal of the roll bar and remove any movement, simple and clever and cheap. I will carry out DIY...
Hi Jon... My only worry with this "fix" is that as you are putting a small diameter nail into the gap around the bush you could be locally stressing the rubber...
I agree, it may only be a fairly temporary fix, although I'm sure someone who tried it said it had lasted for a year or so. Unfortunately I cannot log in to...
Hiya Jon , The photo would be much appreciated . I've had numerous looks as my clunk has been pretty bad for ages , but hasn't got any worse , and have been...
