You can set the sort order of messages? Just click on the link in the date column. Your preferences will be remembered, so you don't have to do it again when you return.
After spending 20 minutes getting the ice of? the windows at 6.30am this morning i couldn't set off to work in my Multi as I couldn't release the handbrake. I...
mine handbrake has frozen on a couple of times in the last 8 years. Normally it has to be pretty cold before it happens. I think my husband ran the hairdryer...
... After spending 20 minutes getting the ice of? the windows at 6.30am this morning i couldn't set off to work in my Multi as I couldn't release the...
Phil, I have seen this problem on the site before, apparently water can get into the sleeve of the break cable and gathers in the lower loop when frozen it ...
Answer: replace the cables if the gaiters (under drivers door) are perished. Make up a handbrake cable protector from old guttering as in the FAQ and it will...
I have read through most of the posts on this subject but still cant find an answer. The inner barrel is intact. I can adjust the angle of washer jets with no...
Hello, just been quoted £140 for front brake discs at the local fiat garage. Can see that they are £66 on shop4parts, for replacements. Does anyone have...
I bought replacement discs from a local motor factor, and they were an exact copy. They fitted easily and performed similarly to the Fiat originals, and I...
Thanks Jonathan, was just a bit wary as a set I bought from a motor factor before were a pain to fit - think it was something to do with some pins being...
Hi Don't know about shop4parts, but just replaced my discs and paid £25 pound a disc at my local car shop. They went on easily with no problems. Mick ...
Phil, This is a perennial problem with the Multi handbrake, and Jonathan's advice is spot-on. When it happened to my Multi (until I could get the cables...
Is it sediment partially blocking the nozzles...happened to me on a few of my cars. I put it down to being a tight g*t I used to use washing up liquid which...
Hi, There are no map lights, there are only 2 bulbs in the fitting and they are switched on at 2 different levels of brightness. This gives the impression of...
Thanks to everyone who responded....got home and cable defrosted..but my ears are now frozen Thanks again phil ... [Non-text portions of this message have been...
Fair point Jon, but we bought a Multi despite it's looks, rather than because of them. The 3x3 seating sold it to The Boss & the drive sold it to me. I tried...
I'm with you on the reliability of a Mondeo. However, I don't hate mine, because I took the precaution of buying a GhiaX V6 (which still goes like stink after...
Thought I'd bump this thread - got the unit unlocked finally - the garage provided the code without cost. But the default volume is anoyingly low. The default...
I seem to be having loss of low down power symptoms with my multi, this seems to point to the EGR valve. Is it not possible to bypass the valve? thereby...
Hi To adjust volume try this: Press menu press the up or down arrows on the right hand side button repeatedly until ON VOL' appears in the display then press...
We determined on this forum a while back that they way to avoid the wear on the inside of the tyre is to set the front tracking to parallel. You lose a little...
I know on the landrover forums and others they blank them off by making a plate that blocks it off completely. However, I suspect that even Fiat had a reason...
Yes! It depends which model you have. The early ones on the 105 were at the front of the engine and a mechanical valve operated by a vacuum pipe. The later...
Hi It looks like mine is the later type. The reason I ask is My other vehicle is a Toyota Surf and any trouble with the egr is solved by just disconnecting it,...
