You can set the sort order of messages? Just click on the link in the date column. Your preferences will be remembered, so you don't have to do it again when you return.
Hey Rick, The door sill plates look right on. I hope to get a set for my 2607 2dr. I was checking my dome light switch and it is burned to a crisp. I was given...
I figured it out. The overheated dome light switch shrunk. So it looks like it was smaller. Installed the switch but the dome light does not work. I have...
IM WORKING ON MY WIRING AND NOTICED IN THE ENGINE COMP. THERES A WIRE COMMING OUT OF A SHAFT THAT IS JUST ABOVE THE COLUMN THAT GOES TO THE GEAR BOX. IS THIS...
Does anyone have a spare piece of interior stainless I'm looking for? It is a piece of the door trim along the bottom which separates the fabric door panel...
The horn wire is under the lower part of the steering column but the wire that comes from the gearchange shaft is the illumination for the gear select quadrant...
Hey Bob--Rec'd the '48 price list. Very informative, well-done and nicely packaged. I was surprised and pleased at the volume of 12 pages of prices and other...
SO WHAT ABOUT EXHAUST?? I HAD SOME BLOCK HUGGERS BUT I COULD NOT GET THE CLEARANCE..... EVEN UPSIDE DOWN CAUSE OF THE STEERING BOX AND CAUSE OF THE VALVE...
I AM USING A SET ALSO FROM A 70S TRUCK, ITS A RAM STYLE THEM GOES DOWN THE CENTER AND ANGLES BACK AT THE EXHAUST FLANGE. I AM LOOKING FOR SOME SHORY HEADERS...
I took your advice and put a Chevy one on the passenger side. Although it was one inch short, I split the difference on the door panel and I doubt even the...
DID YOU LOOK INTO BLOCK HUGGER HEADERS? In a message dated 10/9/2009 1:21:36 P.M. Pacific Daylight Time, b35admofo@... writes: I AM USING A SET ALSO...
Just for the heck of it, I listed my 48' Streamliner sedan on Ebay. I doubt anyone will buy it but we'll see what happens. Check it out. 220495288558 -Rick...
Absolutely beautiful car, Rick. I wish I could buy her, but I have my hands full with my 47 project-car Torpedo. I'd love to see some more interior pictures...
Sorry Bill, just been made redundant from work, finish in 2 days. Been busy trying to organise something else! No luck, so I will have plenty of time next...
I have been trying to free up and remove the brake drum from a 48 rear end . I punched the wheel bolts thru and removed the bolt that went thru the drumtothe...
The brake shoes have worn into the drum leaving a ridge. Unbolt the hydraulic cylinder and possibly the square adjuster housing. The drum should come away with...
Glenn, it took him about a year because they lost my phone number and it was not until I called them that they realized who they were for. It's for my 2-doo...
I have a used but good gas tank for sale 42-48. The reason I replaced it is the rubber hose section between the tank and spout which is not correct but it...
