Found sitting outside in Louisville, Ohio! 2 Door 42-47 Pontiac, Blue and Grey, two doors down from the skating rink we went to today! Couldn't see the nose...
hello all i am back form awhile ago, my name is john soykut, i just tryed selling my 1948 pontiac on ebay but had no bites, it too bad cuz i am in school, but...
Does anyone on the list have a source for a Water Pump Repair Kit for a 1942 Pontiac Straight Eight? Have already tried Kanter. Thanks, Tim [Non-text...
There is a new pump on Ebay at this moment. You need a press to repair a pump or else the pulley can fly of and smash the radiator. I love the car. ... a 1942...
Turns out Raul has one and will ship to the Garage where it will be replaced. Thanks, Tim In a message dated 4/4/2006 1:10:23 P.M. Eastern Daylight Time, ...
I know I'd certainly buy one on ebay first. Theres nothing like losing your radiator, fan, pully and still being out a water pump. Not to mention that special...
i have a 48 2 door with what is believed to be 12,000 original miles, the original seats still under dealer installed seat covers. as i`am only 47 i have never...
If it works In a message dated 4/5/2006 10:44:05 A.M. Eastern Daylight Time, owl_shadow@... writes: I know I'd certainly buy one on ebay first. Theres...
Both front and rear emblems were black as well as under hood and inner fenders. Thanks. ... message board] Re: [Pontiac 42 to 48 message board] Re: Anyone...
Does anyone know anything about a dowel pin that goes in the crankshaft to aling it with the transmission? I finally got the yahoo of a mechanic putting my...
He is trying to bolt the bell housing onto the engine. I'm assuming that when the engine was rebult and re-assmbled by the builder that the flywheel was...
The hole in the crankshaft was there to align the Hydramatic flywheel. I dont think it is used on the std trans. However, the housing should be fitted with...
I'm such a jerk. That is exactly what he is doing....putting the Hydromatic transmission onto the engine. It was late and I had a lot of other things on my...
You really should get the HT manual. It is very specific what you must do. I will help as much as I can but if the flywheel and crank were original, a 3/8"...
Humphrey, You are a life saver. If you could scan the pages and send them to me I woud be forever grateful. My e-mail address is silver_streak_6@......
I do not remember the size of the dowel but there are plenty of alternatives. I dont think you will find one NOS but they should have no problems making one....
Humphrey....You Da MAN!!! Thanks so much for your help. I owe you a big one..don't forget to collect. Mike ... have no ... engineering ... should be ... ...
Humphrey, Can I get a copy of those pages also? One of these days (years?) I hope to pull everything off the frame and that would come in handy. My email is ...
If you guys want a chuckle, check out the Yahoo Pontiac-1950's site, the "Mirrored Pontiac" album. If you think I roont my '48 convert with an LT1, wait till...
I have a 1948 8 cylinder Pontiac engine for sale. It was taken out of a '48 Pontiac Convertable that was being hot rodded. It was driven into the garage then...
Tim, I found the NOS GM waterpump kit. This is what is on the box. part# 1-506785 GRP. 1.003 PKD. 1944 And someone wrote with a Sharpie, "33-42 PONT" With...
Hi Raul. Do you know if the kit contains a shaft, impeller, bearings and seals? I might just buy a remanufactured water pump on Ebay, as the mechanic says...
It has a shaft,with a brass sleeve/bushing. A spring about one inch by one inch,a rubber seal,two round graphite whatchamacallit's, a metal race of some...
46-48 is no. 509138 all engines. The answer is that I would not think so. I would go for the recon pump. They have neoprene seals and would be unlikely to...
