Mark -- For a 1948 Model 25-27 I have the following NOS: Front inner fenders LH & RH Hood hinge with reinforcement Rocker panel moldings Rear fender LH Front...
Hi Paul, Thanks for getting back to me! How much are you asking for the Hood hinge W/Reinf. and Radiator shell w/baff. Thanks, Mark Paul <pedecker@...>...
Hi Paul How much are you asking for the inner fenders?? Thanks! Ellis ... From: "Paul" <pedecker@...> Mark -- For a 1948 Model 25-27 I have the following...
Mark -- 42-48 Hood hinge, with reinforcement, 25-27 All, 507177 $125.00 48 Support, radiator shell, with baffle, All, 510580 $150.00 Prices do not include...
Ellis --- 42-48 Fender, front inner, 25-27 All, LH & RH, 506882/506883 $180.00 pair Prices do not include packing and shipping via UPS, they are a bulky ...
Thanks Paul, very interested. If I were to pick-up, what state are you in. I live in Wellston, Ohio Thanks again, Mark Paul <pedecker@...> wrote: Mark...
Might consider using Greyhound to ship with In a message dated 7/2/2006 6:13:36 P.M. Eastern Daylight Time, musicman39us@... writes: Thanks Paul, very...
Ellis -- Unfortunately there isn't a Greyhound station near me. The only one closed up about 5 years ago. It ends up being UPS Ground, DHL, or freight....
Paul I'm in Pacifica CA. Near San Francisco. Ellis ... From: "Paul" <pedecker@...> Ellis -- Unfortunately there isn't a Greyhound station near me. The...
1948 Silver Streak Straight 8 turns by hand and feel pretty confident it will fire with a little work Frame is solid. Will need some floor pan work (trunk...
Little late at this, but the 1941 Custom Torpedo (they were all Torpedos in 1941 - DeLuxe Torpedo and Streamliner Torpedo) came in 6 (series 24) and 8 (series...
Help! I need a rear bottom seat for my '46 Torpedo. I also need the bottom chrome for the right side. Anyone have these or know where I can get them. Thanks,...
Mike -- Can you be more explicit regarding the bottom chrome for the right side... do you mean a rocker panel molding? I will need your four digit model...
Hi Paul Did you get the message I sent off the group? (Just making sure the spam filter didn't eat it.) Ellis ... From: "Paul" <pedecker@...> Oh goodness...
Paul, It runs along the bottom of the fender and under the front part of the door. It's the the front strip of trim about 4' long. It extends from the wheel...
Mike -- I have the following molding - NOS for your 46-2507 and I believe it is the one you need. Molding, front fender and rocker extension, RH, 508800...
I recently took my 48 Pontiac on it's first *real* outting. It ran great and did a fantastic job climbing some of the steep grades we traveled over. It had...
Have you done any maintenance since the last time it worked fine or made any adjustments to the tranny linkage on the Port side of the engine? It sounds to me...
According to my shop manual,; No upshifts(operates in first only)=Check for governor plungers, plugs missing in parking brake bracket, leak to governor feed...
The car sat for many years w/ the radiator, water pump and fuel pump removed. I have had it back together for several months, and the motor is running pretty...
You can adjust the change ups with the throttle link. I would take the side pan off to check out the governor. It should come out with no touble. Then check...
Bjorn and Gerd - Due to a run of the most rotten luck possible, my phone got turned off! (Other things more important when you have cell phones) My cell phone...
