I'm installing the window channel inside the doors. I have a question about how they're attached. I have the little official clips for holding it in, and they...
Glenn, I asked that same question of the glass shop that cut the glass for my '51 Tin Woody wagon. They use urethane window sealant in the caulk gun tubes....
... I have some Carquest and other part numbers, if you can get these in France, I thought that's where you were located. Also California pontiac restorations...
Hi Glenn- I used the same method Brian described on my car and it wiorks very well. The clips are ok but will unaviodably scrape the paint inside the door when...
I was able to get some from a local upholstery shop. He had it in a roll, and I musta went there when he was in a good mood...he gave it too me. must not cost...
Comments anyone? Thanks, Tim In a message dated 1/25/2007 2:42:01 P.M. Eastern Standard Time, sprad666@... writes: What is the advise on replacing the...
It's kind of a personal choice, if you'd like to replace it then do it. You have a good chance of breaking the glass so you may end up with a new windshield....
Hi Tim- If yours is cracked it will likely leak, if it isn't already. It really isn't that bad a job, but I agree, you may as well plan on a new windshield...
I replaced mine, but my glass had started to separate and I needed new glass anyway. If you're careful, you can get the old glass out OK...it just takes time...
Where can I find this urethane window sealant? For the window fuzzies, I used slow-setting epoxy that I found at the hardware store, and it worked great. I...
Yeah, I kept the old ones, and they had the little spikes bent over inside the channel. But I couldn't figure out an easy, secure way of doing that. So I...
The inner tube has to be a slide fit. Use engine oil which swells the rubber overnight, then use a knife to trim it up. Humphrey ... From: Glenn To:...
The inner tube has to be a slide fit. Use engine oil which swells the rubber overnight, then use a knife to trim it up. It is a bad idea to use urethane...
You should be able to get the urethane at any major auto parts (such as NAPA, carquest, etc) that sells paint and supplies. You likely will not find it at...
When do you apply the oil? Just before you slide the glass into the channel? or should I slide the glass into the channel, then soak the whole thing in oil? ...
Thanks Glenn, Tim In a message dated 2/10/2007 12:55:22 A.M. Eastern Standard Time, humblesmith@... writes: I replaced mine, but my glass had started...
The urethane IS some tough stuff to remove, but if used to bond glass to the riser channels, it'll let go with just a little heat if a glass needed to be...
Hey Guys... I'm new to this site and i'm glad to see theres a site devoted to 42-48 pontiacs........ As the subject line says I have a 42 streamliner and I'm...
Welcome Dan. Is your Car a 48 or 42? Regards, Tim In a message dated 2/17/2007 10:20:43 P.M. Eastern Standard Time, dans123@... writes: Hey Guys... I'm new...
Hi Dan- And welcome to the site. Haven't seen too many of them sitting around as of late, but I will keep my eyes and ears open for a set. Sounds like you need...
Hi Dan, Welcome to our site. Any bumper up to 48 will FIT as A and B bodies shared the same with one exception; the rear center section is longer on the A body...
Dan, I would suggest checking e-bay on a regular basis. Be sure and check if you have a solid core if you plan on replating it and check on the width of the ...
Ok, Lukey, how do you like Kevin's plastic? I put a photo on the msg board of some he just sent me. Now I need to finish the woody so I have a car to put...
