Welcome to all those interested in PSK2k. PSK2k is high speed meteor scatter software written by Klaus DJ5HG. It allows 2 way MS QSO's to be conducted with any...
PSK2k will install on any Windows 32bit machine. PSK2k runs under MATLAB. The sequence for installing the program is to install MATLAB FIRST then install...
Most of the Parameters Screen is self explanitory - users are advised to read the PSK2k User-Guide (downloaded with the PSK2k software) to understand the...
Thanks to all thise that have downloaded and got PSK2k operational. 1. There is a bug at the moment. If you hear CQ and ddouble click on the call to bring it...
Hi Roger,tnx for the hints, the one relative to the sample rate it will be very useful !Just a question, is it possible to define a different directory for...
Klaus has written the following regarding the question of installation directories with MATLAB / PSK2k: The default primary userpath is platform specific: on...
Installed PSK2K finally. Initial start up had good receive audio but no transmit audio. To cut a long story short, it turned out that the Left/Right Balance...
Hi Martin Not really sure why u r seeing Rx gain at 8db - the software does automatically add agc to keep audio level at 3dB. Perhaps Klaus can chip in here to...
Further investigation showed high level even with the receiver switched off. Checked out the interface but found that even with no input to the computer there...
If PSK2k is in QSO mode awaiting a call and you are called then the software will automatically start a QSO. However there are basic criteria the incoming...
If you are setting up QSO's that are likely to take several hours to complete then you need to ensure the parameters are set up correctly to allow the QSO to...
Klaus has just uploaded the new version of MCR_Test, which says by voice the ID-number on all all available sound output channels. This should help identify...
Today I installed for the first time PSK2K. I have to say that the installation is not easy. Even for me and I can say I'm a experienced PC user it was not...
7.6 of the manual states: "The PSK2k signal does not have a constant-amplitude. The TX-output power therefore must be adjusted to an SSB-level if the PA is...
... Interesting thought but think my amp is fine at 400w (<1/2 power) IMD should be >-45dB (old AM ss DBD / TVTX / will check again on two-tone. TNX de Russ...
Many thanks to all those who gave me hints and help in getting PSK2K running today. It really is very different from other similar applications in the way the...
Firstly can I say thank you to all those who have taken the time to install, try and provide feedbacnk on PSK2k. There is surrently an issue with non-decoding...
Output id's are shown in the parameter screen to the right of the input id's. They are only shown by number. Select one,click update button next to callsign...
I am not the best at computers I admit. I have spent 4 hours trying to get the software loaded and running and have failed 100% . Is it me or is there an...
Give me an Idea as to what you have done so far Reg please... I will see if I can help you... Others must be a little busy right now. 73 , De John VK5PO...
ok on the single digit being output and list being audio input devices. next question on the mcr test is: "connect the input to the output with a stero cable...
MCR_test will produce an output to all available audio channels by number and by LL or RR according to their Stereo wiring. Easiest is to route your cable to a...
tks for the reply, i am still stumped on this test. my soundcard has only mic/spkr/input. i did ok on the previous test and got the output channel number, and...
I use a Signalink. In my case the output ID is 2 but that does not mean it will be the same as yours. If you are vox txing then the correct audio channel will...
Hello all, I have a problem when MCR test runing. It stop on the out put ID see on windows "??? reference to non-existent fiel 'ao'. error in ==>MCR_test>usfcn...
Hi Michel, i also cannot run MCR_Test errorfree. I am in contact with DJ5HG since several weeks, but still MCR_TEST is aborting in "Test Sound". He promised me...
