OK, Andrew, I've done a re-install - According to the JMRI debugging
section everything is OK. However I'm getting timeout errors all the
time. I'm connected to a dc supply of 13.5VDC @325mA.
I've tried setting the Com Port timeout settings as high as they can
go. What Baud rate should it be set at?
Flow Control is set to Hardware from a choice x-on/x-
off;Hardware;none.
Anything else I should be looking at?
I'm running this on a portable laptop with a1.6gig processor and 1gig
of RAMunder XPSP2 and all the latest patches.
I've run out of ideas now
Regards
David--- In sprog-dcc@..., "David Butler"
<dandgbathome@...> wrote:
>
> --- In sprog-dcc@..., "David Butler" <dandgbathome@>
> writted:
> I was trying mine on the 1V o/p from a Bachmann controller - so I
may
> be contributing to my woes.
> -----------------------------------------------
> What I meant to write was :-
> I was trying mine on the 12V o/p from a Bachmann controller - so I
may
> be contributing to my woes.
> Cheers
>