------------------------------------------------------------
'scuse me for butting in. I have my sprog USb set to 9600 baud,
hardware flow and iut seems to work OK. Try that David.
Larry Costa
-------------------------------------------------

--- In sprog-dcc@..., "David Butler" <dandgbathome@...>
wrote:
>
> OK, Andrew, I've done a re-install - According to the JMRI
debugging
> section everything is OK. However I'm getting timeout errors all
the
> time. I'm connected to a dc supply of 13.5VDC @325mA.
> I've tried setting the Com Port timeout settings as high as they
can
> go. What Baud rate should it be set at?
> Flow Control is set to Hardware from a choice x-on/x-
> off;Hardware;none.
> Anything else I should be looking at?
> I'm running this on a portable laptop with a1.6gig processor and
1gig
> of RAMunder XPSP2 and all the latest patches.
> I've run out of ideas now
> Regards
> David--- In sprog-dcc@..., "David Butler"
> <dandgbathome@> wrote:
> >
> > --- In sprog-dcc@..., "David Butler"
<dandgbathome@>
> > writted:
> > I was trying mine on the 1V o/p from a Bachmann controller - so
I
> may
> > be contributing to my woes.
> > -----------------------------------------------
> > What I meant to write was :-
> > I was trying mine on the 12V o/p from a Bachmann controller - so
I
> may
> > be contributing to my woes.
> > Cheers
> >
>