Hi, Larry.
No problems with you butting in - all the more help the better!
Unfortunately I've tried that setting.
Spent a bit more time on it after my last post and saw that
DecoderPro was set for paged mode , so changed that for direct mode -
still same problem.
Did notice that no matter what loco I put on the track - its ID
always came up as #3.
Beginning to think it's my laptop at fault rather than the software
and Sprog.
I'll probably end up selling the Forneys and the Sprog when I get
back from skiing - this is wasting too much modelling and houseld
duty time!
regards
David(UK)
--- In sprog-dcc@..., "Larry Costa" <bquilters@...>
wrote:
>
> ------------------------------------------------------------
> 'scuse me for butting in. I have my sprog USb set to 9600 baud,
> hardware flow and iut seems to work OK. Try that David.
> Larry Costa
> -------------------------------------------------
>
> --- In sprog-dcc@..., "David Butler" <dandgbathome@>
> wrote:
> >
> > OK, Andrew, I've done a re-install - According to the JMRI
> debugging
> > section everything is OK. However I'm getting timeout errors all
> the
> > time. I'm connected to a dc supply of 13.5VDC @325mA.
> > I've tried setting the Com Port timeout settings as high as they
> can
> > go. What Baud rate should it be set at?
> > Flow Control is set to Hardware from a choice x-on/x-
> > off;Hardware;none.
> > Anything else I should be looking at?
> > I'm running this on a portable laptop with a1.6gig processor and
> 1gig
> > of RAMunder XPSP2 and all the latest patches.
> > I've run out of ideas now
> > Regards
> > David--- In sprog-dcc@..., "David Butler"
> > <dandgbathome@> wrote:
> > >
> > > --- In sprog-dcc@..., "David Butler"
> <dandgbathome@>
> > > writted:
> > > I was trying mine on the 1V o/p from a Bachmann controller -
so
> I
> > may
> > > be contributing to my woes.
> > > -----------------------------------------------
> > > What I meant to write was :-
> > > I was trying mine on the 12V o/p from a Bachmann controller -
so
> I
> > may
> > > be contributing to my woes.
> > > Cheers
> > >
> >
>