Hi, more butting in,,,,,

I'm pretty sure I'm running pure default, my sprog auto lands on COM
9 as shown in device manager, (9600,8,none,1,none) the 2 "none"s line
up with parity and flow control. I've not had any problems clear
back to install. Running XP sp2 all patches. JRMI 1.75. Java
1.5.0_11.

Just looking at your set up, when I first got my DP I had it running
on 500ma 12v power supply and it was getting occaisional time out
errors with Soundtraxx decoders, I bumped up to a 1 amp PS and
problems went away. You might be underpowered.

Just a thought.

cheers
phil

--- In sprog-dcc@..., "David Butler" <dandgbathome@...>
wrote:
>
> OK, Andrew, I've done a re-install - According to the JMRI
debugging
> section everything is OK. However I'm getting timeout errors all
the
> time. I'm connected to a dc supply of 13.5VDC @325mA.
> I've tried setting the Com Port timeout settings as high as they
can
> go. What Baud rate should it be set at?
> Flow Control is set to Hardware from a choice x-on/x-
> off;Hardware;none.
> Anything else I should be looking at?
> I'm running this on a portable laptop with a1.6gig processor and
1gig
> of RAMunder XPSP2 and all the latest patches.
> I've run out of ideas now
> Regards
> David--- In sprog-dcc@..., "David Butler"
> <dandgbathome@> wrote:
> >
> > --- In sprog-dcc@..., "David Butler"
<dandgbathome@>
> > writted:
> > I was trying mine on the 1V o/p from a Bachmann controller - so
I
> may
> > be contributing to my woes.
> > -----------------------------------------------
> > What I meant to write was :-
> > I was trying mine on the 12V o/p from a Bachmann controller - so
I
> may
> > be contributing to my woes.
> > Cheers
> >
>