You can set the sort order of messages? Just click on the link in the date column. Your preferences will be remembered, so you don't have to do it again when you return.
--- just joined and added my location here in north devon
while I am on here can you confirm that my lenz set 02 will drive
trains via an interface from the computer, but not program them
I have sprog 11 (usb) any way so just checking that I can drive trains
that way.
what would I need to use sprog with multi train set upto drive them
trevor
Hi all, I've set up a Frappr map for anyone who wishes to add themselves and tell other users where they are: http://www.frappr.com/sprog-dcc Enjoy! Andrew PS...
... while I am on here can you confirm that my lenz set 02 will drive trains via an interface from the computer, but not program them I have sprog 11 (usb) any...
Trevor, Sorry, I don't know about the capabilities of the Lenz set 02. I would have thout you could program trains using the Lenz computer interface. You...
... No it just works 8) Although some day I'll need to get a list of the USB messages that are used, write a driver and buy a USB one. Until then I'm happy...
... about ... The USB version uses Virtual COM Port (VCP) drivers so it behaves just like the serial version as far as software is concerned. No need for ...
... Thats actually all I needed to know. Linux has an FTDI chip driver already for just about anything using the FTDI protocol. Just needs the vendor/device...
... own ... the ... I'm can't afford the $2K per year for a unique vendor ID so: Old USB SPROGs (pre SPROG II) use the default FTDI VID and PID and should just...
Andrew, I'm using an original version 4.0 SPROG which was recently upgraded from firmware version 3.8 to 3.9. Since performing the upgrade I've noticed ever...
Bob, I haven't seen that problem before. What output do you get from an M command sent to the SPROG? I'm wondering if one of the mode bits are somehow stuck in...
I am just starting to use the sprog I bought last year. I saw some messages re firmware update. Should I look to see if this is a needed upgrade? Stan Stan...
Stan, You do have an older version but if it works OK for you then there is no need to upgrade. You will need to upgrade if you use digitrax decoders and wish...
I have not had a problem, but I am saving to purchase a couple of Tsunami decoders. What should I do to get the sprog upgraded? Thanks Stan Stan Hall 2402...
Stan, As you are in the US, the best thing would be to contact Bill Chown (se the SPROG DCC website) as there are potential problems in doing it yourself. ...
Offline 
Send Email
