Hi all (again)

I have now tried another loco which was known to be working fine. It reads the
CV's fine, but is not wanting to run under throttle at all. No response or trips
out.

Any suggestions ?

Andy

--- In sprog-dcc@..., "andy_sollis" <Andy@...> wrote:
>
> Hi Andrew.
>
> I have tested the loco away on my dad's layout with a Dynamisys and the loco
performed faultless. No shorts (other than when it fell off the track at the V
of a point) found at all...
>
> So this is the second loco that stops running on the throttle, but will
program fine ?
>
> I will try a factory fitted plug and play loco tomorrow to see if the same
happens then with Sprog to find if it has gone faulty after all these years or
if it is just a case of a dose of bad luck !
>
> Andy
>
>
> --- In sprog-dcc@..., "andrew_croslanduk" <andrewcrosland@>
wrote:
> >
> > The !O indicates an overload (or at least the SPROG thinks there's an
overload).
> >
> > Are you sure everything on the chassis is 100% isolated where it should be?
> >
> > Andrew
> >
> > --- In sprog-dcc@..., "andy_sollis" <Andy@> wrote:
> > >
> > > Hi Andrew,
> > >
> > > Yes that may help - Not something I ever use the comand monitor - Anyway,
here goes.
> > >
> > > cmd: "A 3"
> > > rep: "P> "
> > > cmd: "-"
> > > rep: "P> "
> > > cmd: "+"
> > > rep: "P> "
> > > cmd: ">28"
> > > cmd: ">28"
> > > rep: "P> "
> > > rep: "P> "
> > > rep: "!OP> "
> > >
> > > Andy
> > >
> > >
> > > --- In sprog-dcc@..., "andrew_croslanduk" <andrewcrosland@>
wrote:
> > > >
> > > > Andy,
> > > >
> > > > In DecoderPro, open the command monitor window and then try again. What
message(s) do you see the SPROG shuts down?
> > > >
> > > > Regards,
> > > >
> > > > Andrew Crosland
> > > >
> > > > --- In sprog-dcc@..., "andy_sollis" <Andy@> wrote:
> > > > >
> > > > > My Original Sprog 1 is suddenly shutting down when I use the Throttle
?
> > > > >
> > > > > Originally I thought this was motor related to a Hornby Class 50 which
I was working on for a friend (Mine has never worked on Sprog - I just assumed
it was a current draw thing), but now I'm working on a Split Chassis Bachmann A4
and this is the same, I can't get above 1\4 power before sporg shuts down. I
know this is not a short as when this occurs, Decoder Pro also freezes -All I
have to do is turn the power light back on.
> > > > >
> > > > > I'm using the same power supply I have used for the past 7 years (Gosh
have I has it that long ?)
> > > > >
> > > > > Anyone have any thoughts ?
> > > > >
> > > > > Andy
> > > > >
> > > >
> > >
> >
>