Hi,I have a Sprog unit and I've just started to program my decoders with mixed results. I have successfully programed Loksound decoders but I've run into a...
Thanks Paul....I'll continue using the SPROG as is and see what I can do with the rest of my docoders. The one particular engine I'm having problems with was...
Barry, yes, the engine runs ok on my layout. I'm just looking to lower volumes etc. When I first tried it, it did read back as an LC decoder on Decoder Pro,...
Hi After a seven year break from the hobby I have returned to what seems to be a whole new world — I had mistakenly thought with the general availability of...
Hi All I now have Windows 7, and have today downloaded Java version 1.6.0_25 followed by JMRI 2.12 Decoder Pro. Device Manager shows Serial Port 3 which is...
... the software setup. ... solution. ... 1.6.0_25 followed by JMRI 2.12 Decoder Pro. ... preferences in Decoder Pro. ... (306). ... I have had the same...
Thanks, Douglas That method has worked for me, too !! Sprog now works on Windows 7. I shall now tackle the ancient laptop which has XP Home and is hopefully...
Wow ! A little more sweat and Sprog now also works on XP Home ! I used Driver Detective to update all drivers but had to remove the audio and modem drivers...
It should be possible to move the COM port allocation of a device within Windows (any version including/after XP). That would deal with devices which insist...
Thanks for your input, Nigel Sprog has failed again on the XP Home laptop and I wonder if it would be simpler to disable the modem and audio bits to allow...
Hi Nigel Having tested under Windows 7 and the XP machine, I have managed to allocate COM3 on both machines and move the troublesome modem on XP to COM11. All...
Hi Mike How about a program where you click on a button to choose a loco number between 1 and 10, click a button to decide whether to go forward or backwards,...
I've been using my Sprog 2 for several months now and very pleased with its effectiveness. Last time I used it though the throttle output appeared to 'fade'...
Only speculating here, but could it be that the loco has an unusually high current draw, and the power supply to the sprog is going into fold back shutdown. ...
Thanks to you both for your responses. Andrew Closing the throttle and opening it again will bring it back to life. Julian Maybe, I'll try it with a couple of...
Do you do anything to the power control between opening and closing the throttle? What does the power LED do? Is JMRI set to SPROG mode or SPROG command...
Well, I suppose inevitably that when I tried to replicate the problem last night everything worked OK! The loco in question drew 200 to 250 mA and the power...
When I go to use the speed tables I am not seeing any of the write to or read to options on the bottom of the screen tried adjusting pixel sizes and they are...
It almost sounds like you are in edit mode rather than in programming mode. Do you have the read or write buttons on any of the other tabs? Regards Kevin ...
As far as JMRI, is it the install process or too many options/controls that makes it unattractive for your uses? I'm using Sprog/JMRI for a tree layout too. ...
Thnks for your reply but I think Kevin may have found the answer It may be I was in edit mode and not programming I will See ... [Non-text portions of this...
