There is no straight forward route from the engine bay to the boot area.
When I setup mine, under the bonnet, under the windscreen on the passenger
side (what would be the back of the glove compartment areas), I drilled a
hole there and fed the wire through, then get some hot melt glue, or if you
can find a rubber grommet good and water tight enough to fill the hole in,
and protect the wire from shearing on the sharp metal (thus shorting the
battery!). Run the wire under the carpet just beneath the door(s) on the
passenger side also, and under the rear seats into the boot area. That
should sort you out.
Unless anyone's got any other better solutions, this would be your best bet.

Dan

-----Original Message-----
From: stuartspeugeot306club@...
[mailto:stuartspeugeot306club@...] On Behalf Of bemendozer
Sent: 01 April 2006 21:24
To: stuartspeugeot306club@...
Subject: [Stuart's Peugeot 306 Club] Amp lead

Does any one know the best way to run a live wire from the battery
to the boot for my amps? i was looking today and I cant find any
straight forward way, do I need to start drilling holes?
Cheers
Rob





http://uk.groups.yahoo.com/group/stuartspeugeot306club

To unsubscribe from this group, send an email to:
stuartspeugeot306club-unsubscribe@...
Yahoo! Groups Links