stuartspeugeot306club : Message: Re: Grey smoke!

Yes it is a diesel, the timing belt was changed
20k miles ago all was ok after the change. I
changed it again when I took the head off, and set the
timing with the bolts in the pullys etc but have not
found anyone other than the Pug dealer who has a dial
guage and addaptor, is there any other way of setting
the pump timing ?

Expand Messages

Author

Sort by Date

try 28 front 26 rear it is a good place to start. mp...

palmermotorsport
palmermotors...

Feb 27, 2002
1:17 pm

Yes it is a diesel, the timing belt was changed 20k miles ago all was ok after the change. I changed it again when I took the head off, and set the timing...

phil306xtdt

Feb 27, 2002
1:21 pm

Does anyone have a Haynes 306 manual they want to sell ? (wanted for an M reg 306 XLD) Can someone tell me what make and model alternator is fitted to a...

v321uk

Feb 27, 2002
5:45 pm

Are you sure the rev counter sensor is taken from the alternator? I thought it was taken from a sensor on the gearbox! I'd love to know where to look...

srd0225

Feb 27, 2002
8:07 pm

Two posters on uk.rec.cars.maintenance have said that the sensor pick off is from the alternator. But that news group is for general car maintenance not ...

v321uk

Feb 27, 2002
10:56 pm

in theory the only way for an accurate rev counter reading on a diesel is on the timing pump my iveco has a small generator on the pump the alternator would be...

palmermotorsport
palmermotors...

Feb 28, 2002
7:01 am

The rev counter sensor is at the back of the engine at the end where the gearbox bolts on. It is a top dead center sensor used on petrol engines when the...

phil306xtdt

Feb 28, 2002
8:37 am

I have found the sensor but cant see whats holding it in place. Cant see the small bolt you mention. Could you clarify where it is please. Many ...

v321uk

Mar 2, 2002
2:17 pm

Jack up the front of the car, lie on your back and look up behind the engine, just adove the long driveshaft where it goes in to the diff housing. The sensor ...

phil306xtdt

Mar 7, 2002
8:30 am

Does anyone know if there are any 306 breakers not too far from the London area ? Does anyone have a 306 XLD owners handbook (M plate)... the type that...

v321uk

Mar 8, 2002
2:43 pm

I don't think there are different handbooks for the different models. I have the handbook which came with my M plate XTdt. It's not for sale but if you need...

srd0225

Mar 8, 2002
8:00 pm

Thanks for offering to look at the book. I sometimes get a warning light. It is at the top left hand corner of the speedo area. Its like an oval...

v321uk

Mar 9, 2002
8:07 am

a5 salvage near dunstable on the a5 is the best around mail order and you can remove the bits yourselves all late and early cars. i haved used them for a...

palmermotorsport
palmermotors...

Mar 10, 2002
7:09 am

I think you'd better email the sketch for me to be sure but from the location, it sounds like it could be the 'Water in Diesel' indicator. They are prone to...

srd0225

Mar 10, 2002
7:39 pm

Hi, I Have recently realised a need for a new car. After looking at some old What Car magazines I have seen that the 306 has done extremely well! The problem...

tom_tt_2000

Mar 11, 2002
9:15 pm

Hi, my 306 website page (http://www.radox.freeserve.co.uk/306.htm) lists the problems I've had with my M-reg 306 XTdt. Most of them would apply to any 306. ...

srd0225

Mar 12, 2002
1:21 pm

Yahoo! Groups Tips

Did you know...

Messages