Hi I'm really not sure where to start looking on this one. Both of my reversing lights don't work. I've replaced the bulbs, and even had a multimeter on the...
Hi dan common fault is the switch it has a ball bearing in the end of it and gets stuck it works when you select reverse its mounted on the gear box with 2...
Hi, slight problem with window wipers soon as start up car they start working cant stop them anybody help there driving me barmy cheers julie [Non-text...
Hey, help!!!! I initially had a problem with it running the battery flat, probably because of my boot install, but I'll address that myself another time. ...
Hi, Sounds like a really really really dead battery. This would mean no spark and therefore no ignition. Make sure the terminals / connections on the battery...
Where in all that's holy is the diagnostic socket?! The fault finder manual says most are green, but the only green connectors I can find are either ...
Hi, Look behind the fuse box cover at the end of the dash (right and below the steering wheel). Make sure you plug in when the ignition is OFF. Ian. 306,...
I had a look for it this evening. Couldn't seem to find it. The only empty port I could find behind the fuse box cover was a long oblong one, 15/20 pins or so,...
Hi Again, The one on the wife's 306 is a 16 pin oblong female connector, black and white in colour. It's to the left of the fuse box (remove the cover) under...
Hi I have a 1997/8 (R reg) Peugeot 306 XLDT with an alarm problem Basically the alarm has a mind of its own and decides to go off whenever it feels like it...
Hi All As if the alarm problem wasn't enough, my 306 XLDT has now developed a severe judder at around the 45 - 50 m.p.h. mark The judder does not appear to be...
hi mate cant help with alarm my 3067 dt done the same thing when i turned alarm on the judder u might want to get checked asa that could be a gearbox mount...
Mine juddered too, especially under acceleration, also after I'd had one driveshaft replaced. I ended up having the other replaced also and I've had no problem...
Hi, I have had my 306 for almost 5 years now and a lot of money out of my pocket on maintenance. 1 alarm goes off all the time and has to be set to internal...
Hi, I have had my 306 for almost 5 years now and a lot of money out of my pocket on maintenance. 1 alarm goes off all the time and has to be set to internal...
Hi, You must be cursed! I've had virtually no problems with a 306XRd and a later 306 1.6LX. You don't happen to live near a cliff with a road? Only joking. ...
Some more points to add to much nice long list: I have bought a new radiator aluminium on ebay for £100 (ariving next week) so the engine should run a little...
'R' reg 306 1.9 Diesel (non Turbo) I need to replace the sump. I can't get it of due to the power steering pump brackets. I am having difficulties trying to...
Hi all, looks like a great group. Bought myself a white 306 XLTD a few months back... Unfortunately, one night a signpost, and farmers gate followed by a ditch...
Hi, This, as always, could be many things. Is the car still as quick as it used to be at the lower end of the rev range, before the turbo cuts in? Check ALL...
have tried checking pipes, i spent an hour and a half, and two wd40 cans, cleaning engine bay so i could get a good look. Tried checking all obvious pipes but...
Hi, As i said before the radiator is the first job for me. I got my haynes manual out opened the bonet went to take the air inlet pipe out to find the bolts...
hi the heater blower in my 306 d turbo has recently stopped working. tested the blower it works fine, wen i switch the ignition on there is a live feed to the...
I have just noticed on the front of the factory fitted radio/cassette player in my 306 there is a socket labelled CD. Does anybody know what type of connection...
Sounds like you have the Blaupunkt 3040 unit which came with the higher spec 306 models rather than the much more common 3030 unit. The 3040 does have the CD...
Stuart, yes it was a 3.5mm jack. After going in to about 5 shops I got a suitable cable and pressing the src button to select the audio. Now I can have my mp3...
Hi all, am currently replacing front end parts of my 306 white xldt 97 p phase one. Am i right in thinking that i can use a bumper of a phase two aswell as a...
Hi, if you have read my other posts, after my front end accident, my turbo hasnt been working properly. ive now worked out that either the oil feed to the...
Hi, After reading your previous posts......... After having a bent feed pipe the turbo is probably damaged. The shaft bearings run on a film of oil, no oil,...
