You can set the sort order of messages? Just click on the link in the date column. Your preferences will be remembered, so you don't have to do it again when you return.
I have no button on my ignition key and the spare key i got cut wont start the engine.it sounds like it wants to start but doesnt,gotta check for sure weather...
it could well be. as far as i could tell, there was no chip inside either of the keys. it was just a block of plastic on the end of the key itself. but both...
... It may be the indicator switch as well as they are known to be a problem sometimes. i had to change mine as the clicking was getting worse. does ti get...
dont know if anyone else has had any problems like this but sometimes when i come to a roundabout or junction i change down to first to get ready to pull away...
I vaguely remember my 306 was sometimes a little reluctant to engage first gear sometime. I think I got into the habit of selecting the gear just before I came...
I don't think there is a synchro for first, could be wrong..... I usually wait until I'm stationary and select 3rd then 1st. 306 LX Est. (1.6) 306 Xrd (Wish...
I have got a 1998 306 1.9td and i am only getting about 30 to the gallon,it is ready for a service but should that make SO much difference to the consumption...
... Well, I've had a 1998 1.9td Meridian hatch (since new) and, over its life to date (71k miles), it's averaged around 45 mpg so yours sounds just a bit...
cheerz for ya last message stuart, iv drove car and done wha you said, to get it into gear before i actually come to a stop seems to work,but it means i have...
Had the gears looked at but they couldnt fine any fault they said they drove it 20 miles or so,they changed the gearbox oil hoping that would help,but its...
... a good service can make an awful lot of difference especialy the fuel filter I have found, also I run diesel injector cleaner in my tank every so often.I...
... they ... would ... ya in ... have go ... know ... engage ... neutral ... sure ... again ... you could try getting underneath the car and greasing the...
I have a 97 1.9 TDI with a cable for the clutch. It is very stiff to use and even a new cable has not helped. Any advice on how to make it easier would be a...
... We have had the same problem for years in a 306 Cab. even after a new cable .I pull the tension spring off the clutch pedal and lightly grease it ,this...
Any luck with finding out what is causing the white smoke, or the solution? My 306 1.9 TD 1997 R reg is suffering exactly the same symptoms, starts absolutely...
Hi have just done a head gasket on my pug. But on taking the coilpack off like an idiot i diconnected the ht leads Can anyone that has a 306 2l xsi 8valver...
Hi all, My wife's 306 (1999 "V" 1.6 Estate) washer pump stopped working yesterday and I wondered if anyone knows which fuse feeds the pump and / or the relay? ...
hi i have an r reg peugeot 306 lx petrol on some if not all mornings when i try to start the car by turning the key i turn the key as to start the engine but...
i have a problem with no hot air or very very littlecoming out of the air vents not sure if its the heater itself allthou a slight heat comes out or the...
When you say you turn the key on and off about 4 times, when it eventually does turn over does it sound ok or does it sound slow and laboured? If it's slow I'd...
Hi, I'd suggest checking the coolant pressure & level. The highest point of the system is above the filling point, so sometimes it doesn't get filled,...
Thank you Alan ... point of the system is above the filling point, so sometimes it doesn't get filled, which might stop hot water getting to the heater matrix....
hi thanks mate i had a mechanic come out to check the car and he found that it was the solanoid on the starter motor so a new one was fitted.thanks for the...
hi mate i had a mechanic i know check the car and he found it was the solanoid on the starter motor so a new one was fitted thanks for the help mate ... From:...
Could anyone tell me how to change the front fog lamp bulb in a 1999 306 please cos i don't wanna start pulling the plastic off if your ment to get it from...
According to Haynes, it's like mine, where you need to take the front bumper off, and then remove the bolts holding it on. Unless someone sees something I've...
ah the bulb, sorry, anyways, if there are two screws on the front of the fog lap glass, you've to undo them, then remove the surround etc to get in, failing...
Stuart's Peugeot 306 Club has moved to www.stuartdalby.co.uk/peugeot306forum.php <http://www.stuartdalby.co.uk/peugeot306forum.php> . All 1,380 posts from when...
