Thanks Magnus and Dr. Zapp for the tips. Maybe my problem is that I
redrew all the components I use. Smaller sizes. I uploaded the
schematic and libraries I used for this design in the files section.
Note that the lines from the AP out to the input's normal lugs are NOT
wires. They are just lines.

Thanks for taking a look.

p.


--- In tinycad@..., "Magnus Beischer" <magnus@...> wrote:
>
> --- In tinycad@..., "peng3002" <megaOhm1@> wrote:
> >
> > I figure I'll add my post to the growing list of "what the hell is
> > wrong with the design rules checker!?!?" posts. Here's what happens
> to me:
> >
> > Finish schematic design
> > Run Design Rules Check
> > Finds errors (usually many)
> > I delete wires in problem area(s)
> > Rewire problem area(s)
> > Run Design Rules Check
> > Error free (usually)
> > Save work
> >
> > If I closed the schematic I just fixed and saved, then open it again,
> > ALL of the errors are back!!!!!!!
>
> For me this is a known problem. I use 2.5.10 and have the problem if I
> draw components out of grid (usually when I have forgotten to turn the
> grid on. I use no grid when I move texts). Note thar someThis is
> because tinycad makes a connection when you draw a line, even if you
> have a grid problem on a component. The problem only shows after you
> have saved and opened the design again and you make a design rule
check.
>
> Put the schematic _and_ the lib in the files section and I'll test it.
>
> What grid do yo have when working with the schematics?
>
> A very important note is that "Snap to grid" in the menu is set for
> every page, so if you are on page 1 and set "Snap to grid" that is not
> set for your other pages.
>
> // Magnus
>